What's new
What's new

Using more tools than spots in the toolchanger

Mskiin

Plastic
Joined
Aug 29, 2018
Good evening all,

I am attempting to touch off more than the 10 tools in my umbrella changer. All of the 10 tools in the changer cycle normally, but I want to use say tool 11, but when I hit M06 t11 it stays on the current tool and wont put the current tool back in the pocket, and wont recognize that tool. It just stays on the current tool. Any help would be appreciated. Thank you!
 
I used to have that issue. I reserved T10, and left it empty in the carousel. In the program I would call out T10 and use H11 and D11 (have to turn off matching T and H codes in the settings) It would load the T10 (which was empty). I would then load the external T11. Or T12. Or T50
 
I used to have that issue. I reserved T10, and left it empty in the carousel. In the program I would call out T10 and use H11 and D11 (have to turn off matching T and H codes in the settings) It would load the T10 (which was empty). I would then load the external T11. Or T12. Or T50



Awesome. That's what I needed. THANK YOU SOOOOOOOOOO MUCH!!!
 








 
Back
Top