Waakzaamheid
Cast Iron
- Joined
- May 17, 2010
- Location
- Massachusetts
Hey guys. So I've got thrown in the deep end here a bit at my new job. Out milling guy no longer works here and I'm left trying to figure out how to run our Haas vf2. I have a little milling experience on a Hurco at an old job.
This machine has a tool probe and work probe. The work probe is pretty self explanatory, I touch and it zeroes that axis. I'm a little confused on the tool probe though. It's mounted on the table, and when I touch off it does...something, but how does it relate to the work zero? I don't know where the tool probe zero is, do I? Does this make any sense?
This machine has a tool probe and work probe. The work probe is pretty self explanatory, I touch and it zeroes that axis. I'm a little confused on the tool probe though. It's mounted on the table, and when I touch off it does...something, but how does it relate to the work zero? I don't know where the tool probe zero is, do I? Does this make any sense?