As9100d
he is half right
there is prox switches and lock pins on the new doors,,, on my 2018 vf2ss ( same system ) I just pluged off the air pipe back in the air lube cabinet and that stopped the lock pin then I put some like 1 1/2" by 3" by about 3/8" thick magnets from home depot and a little flat bar above the door handles and there just held there with the magnets and when the doors are all the way open the prox switchs think the doors are shut ,,, to manually load tools just close one of the doors a couple inches and the prox switch thinks the doors are open .......
the "only modification made to the machine was cutting like 2" of the air line off and folding it over and putting tape on it to seal it off ,,, if I even need to I can still just plug the air line back in and pop the magnets off and its back to stock ..
***********************************************************
on the new DM2 I had to buy a second prox switch and wire it into the original switch ,, so it thinks the door is closed if its all the way open or all the way closed ,,, I do a lot of engraving and don`t want to open and close the door every 10 seconds to swap parts .
If you have questions about it just ask