Shawn_Laughlin
Aluminum
- Joined
- Mar 28, 2019
I’ve noticed this 3 times and the first two times I thought i was just was just imagining things but. So, If I have z selected and do my jog and then switch to x, when I start to spin the handwheel the z will travel in whatever direction Im turning the wheel for about a half inch and then the selected axis begins to travel like it’s suppose to.
I’m almost positive I read someone else had this problem but not 100 on if it was a haas and ngc but I think it was.
Anyone else had their machine do this?
Like I said it’s only happened 3 times but that could be a real headache if say your probing the top of a part and the z drops down to smash your probe when go to move in x or y.
I’m almost positive I read someone else had this problem but not 100 on if it was a haas and ngc but I think it was.
Anyone else had their machine do this?
Like I said it’s only happened 3 times but that could be a real headache if say your probing the top of a part and the z drops down to smash your probe when go to move in x or y.
