Likes: 0
Results 1 to 3 of 3
Thread: Posting test
-
09-07-2017, 12:38 PM #1
Aluminum
- Join Date
- Aug 2017
- Country
- UNITED STATES
- State/Province
- Virginia
- Posts
- 60
- Post Thanks / Like
-
- Likes (Given)
- 27
- Likes (Received)
- 23
Posting test
I tried posting a new thread in the VN/USA Heavy Iron forum but got a message it had to be approved - that was close to 48 hours ago. The thread was posting scans of the VN 1R-series operating/parts manual which, to my knowledge are not to be found on the Internet, so it should be beneficial to other folks. Is there anything I've done wrong?
Thanks,
Ben
-
-
09-07-2017, 06:10 PM #2
Aluminum
- Join Date
- Aug 2017
- Country
- UNITED STATES
- State/Province
- Virginia
- Posts
- 60
- Post Thanks / Like
-
- Likes (Given)
- 27
- Likes (Received)
- 23
I see the thread is up now, thanks!
-
09-12-2017, 09:13 AM #3
Aluminum
- Join Date
- Aug 2017
- Country
- UNITED STATES
- State/Province
- Virginia
- Posts
- 60
- Post Thanks / Like
-
- Likes (Given)
- 27
- Likes (Received)
- 23
On Sunday the 9th I posted a second thread in the VN/Heavy Iron forum which again stated it required approval. To give mods some time, I waited three days until today, but I still don't see the thread. If moderators are busy and haven't gotten around to it, that is fine - it's not my intent to complain. I'm just a bit confused as I read the entire forum FAQ and didn't see any mention regarding restrictions placed on new members. I'm also unsure why I can post in this board without approval and not the VN board. Are there any other restrictions, such as private messages?
Reply With Quote
Bookmarks