What's new
What's new

Posting test

thebencarter

Aluminum
Joined
Aug 23, 2017
I tried posting a new thread in the VN/USA Heavy Iron forum but got a message it had to be approved - that was close to 48 hours ago. The thread was posting scans of the VN 1R-series operating/parts manual which, to my knowledge are not to be found on the Internet, so it should be beneficial to other folks. Is there anything I've done wrong?

Thanks,
Ben
 
On Sunday the 9th I posted a second thread in the VN/Heavy Iron forum which again stated it required approval. To give mods some time, I waited three days until today, but I still don't see the thread. If moderators are busy and haven't gotten around to it, that is fine - it's not my intent to complain. I'm just a bit confused as I read the entire forum FAQ and didn't see any mention regarding restrictions placed on new members. I'm also unsure why I can post in this board without approval and not the VN board. Are there any other restrictions, such as private messages?
 








 
Back
Top