Texasbowhunter
Aluminum
- Joined
- Oct 11, 2019
Good afternoon guys...I'm in need of a bit of guideness here on the topic of belts...I picked a clean Clausing 12 x 36 Clausing 5930 series lathe and have cleaned it up and been using it to get acquainted with the magic it has...
I have determined that I Should replace the belts for the unit...They seem dry and cracked and I have the time to change them now rather then later when I'm in the middle of a project...
I have a manual for the unit's serial number and have found that the 2 belts I'm seeking are:
Timing Belt- 051-051 serpentine belt
Motor Belt- 051-034 V-Belt
This is a manual speed lathe
I have read that the mfg. is very proud of there belts and there are other sources out there...
Help me source out the places where I can obtain the belts required for the replacement...or the new part numbers for these belts so I can find them...
Thanks for the help
Paul
I have determined that I Should replace the belts for the unit...They seem dry and cracked and I have the time to change them now rather then later when I'm in the middle of a project...
I have a manual for the unit's serial number and have found that the 2 belts I'm seeking are:
Timing Belt- 051-051 serpentine belt
Motor Belt- 051-034 V-Belt
This is a manual speed lathe
I have read that the mfg. is very proud of there belts and there are other sources out there...
Help me source out the places where I can obtain the belts required for the replacement...or the new part numbers for these belts so I can find them...
Thanks for the help
Paul