danz503
Plastic
- Joined
- Jul 5, 2011
- Location
- oregon-usa
hoping some one has some good experience with a problem like this. drive spindle on my cicny has .002" wear on a bearing surface. the bearing actually fell off during disassembly. this is the top bearing in the lower set of bearings #7007ctynsul p4. one suggestion was chrome it. a good fix, but does anyone have another short of building a new shaft? i was thinking a knurl with some sort of epoxy, loctiite or devcon. any experience with that type of fix. i use this mill almost daily, but trying to keep fix to a minimum
DanZ
DanZ