gear cutter
Cast Iron
- Joined
- Oct 16, 2010
- Location
- MO, USA
I bought a used Curtis compressor a while back. It is a C 98. It was running when I bought it but it was under a lean to on the side of the guys building. It came up to pressure fine and seemed to operate as I think it should but it looks rough.
I would like to have it gone over by someone that is more knowledgeable about these than myself.
I am going to replace my Ingersol Rand 5 HP vertical unit with this one. The IR just isn't made for the strain I am putting it under.
Can anyone recommend a reputable outfit that would be able to handle this. If it needs to be rebuilt that's fine I just want it to get done right.
I would like to have it gone over by someone that is more knowledgeable about these than myself.
I am going to replace my Ingersol Rand 5 HP vertical unit with this one. The IR just isn't made for the strain I am putting it under.
Can anyone recommend a reputable outfit that would be able to handle this. If it needs to be rebuilt that's fine I just want it to get done right.