lake_harley
Plastic
- Joined
- Jan 2, 2019
I'm new here and am looking foreward to being a part of the Practical Machinist forum.
I've had an old Enco lathe in my shop for years. I knew it had issues when I bought it really cheap and I am finally getting around to checking it over better to hopefully resurrecting it. It's a model 110-0818 and measures out to about 9" X 19"
I've done some searching for parts and it appears that not much is out there of the type of parts that I think I need; a gear of two, cross-slide and compound parts and a few other items. But, in seaching I came across this Grizzly 9 X 19 lathe that looks just like my Enco. As best as I can tell it has similar or identical specs to my Enco. 9" x 19" Bench Lathe | Grizzly Industrial
Has anyone had any experience using parts from Grizzly for another brand (Enco?) lathe?
Thanks, in advance for input or guidance.
Lynn
I've had an old Enco lathe in my shop for years. I knew it had issues when I bought it really cheap and I am finally getting around to checking it over better to hopefully resurrecting it. It's a model 110-0818 and measures out to about 9" X 19"
I've done some searching for parts and it appears that not much is out there of the type of parts that I think I need; a gear of two, cross-slide and compound parts and a few other items. But, in seaching I came across this Grizzly 9 X 19 lathe that looks just like my Enco. As best as I can tell it has similar or identical specs to my Enco. 9" x 19" Bench Lathe | Grizzly Industrial
Has anyone had any experience using parts from Grizzly for another brand (Enco?) lathe?
Thanks, in advance for input or guidance.
Lynn