Rockwell 20-916 MODEL 9 HORIZONTAL BAND SAW question

PKSharp · Aug 5, 2020

Hi all,i just picked up a Rockwell 20-916 MODEL 9 HORIZONTAL BAND SAW and looking for some answers w\about the non-driven wheel. Bearings are fine but the

axle seems to long is that normal for this model? see space between wheel hub and keeper nut/washer on end of shaft. The part the attached to saw has (120 1067) cast on it.

thanks for any helps your can provide.

PKsharp

eKretz · Aug 6, 2020

There likely shouldn't be anywhere near that kind of clearance. Check for wear on the faces of the parts. If nothing excessive, someone may have had it apart previously and not put a spacer back. If you can find a parts manual that should clear it up.

lazz · Aug 6, 2020

Here could be the manual on Keith Rucker's site VintageMachinery.org

These are good saws when the gear box works.

PKSharp · Nov 5, 2021

eKretz said:
There likely shouldn't be anywhere near that kind of clearance. Check for wear on the faces of the parts. If nothing excessive, someone may have had it apart previously and not put a spacer back. If you can find a parts manual that should clear it up.

thanks for the info was off line due to medical reasons but getting back to saw rebuild.

PKSharp · Nov 5, 2021

thanks for the manual file realy helped I was off line due to medical reasons but getting back to saw rebuild.

Search

Largest Manufacturing Technology Community on the Web

Search

Rockwell 20-916 MODEL 9 HORIZONTAL BAND SAW question

PKSharp

Plastic

Attachments

eKretz

Diamond; Mod Squad

lazz

Stainless

PKSharp

Plastic

PKSharp

Plastic

Similar threads