Hello.I need Your advice with scraping tapered gib.I glued 1mm steel plate to the gib nonworking side because ,it gets too thin after ways scraping.My problem is that iv scraped this gib to 70% lenght and there is still wiggling on the top .Down side is fine but it looks like that my scraping is useless.Berfore I'v started to scrape gib with surface plate to get both surfaces flat.Then installing gib by rubber hammer into dovetail,and removing by hammering the saddle.
Iv marked on the photo what's going on.
Iv marked on the photo what's going on.