rklopp
Diamond
- Joined
- Feb 27, 2001
- Location
- Redwood City, CA USA
Some prior owner or operator spun a tool in the vertical spindle of my Aciera F5. There is a ring of raised metal that is too much to stone out. The taper is standard NMTB40 with a 5/8"-11 drawbar. The spindle is a removable cartridge that can be sent out as a unit so the taper can be ground on its own bearings. I am looking for a good grinding outfit to clean this thing up. Is on-site grinding worth considering, or will it cost the moon due to travel expenses? I don't have a compressor big enough to drive an air turbine, if that's what the on-site service uses.
It would be easy enough for me to send this thing someplace.
Thanks for any advice!
RKlopp
It would be easy enough for me to send this thing someplace.
Thanks for any advice!
RKlopp