leop
Plastic
- Joined
- Mar 11, 2013
- Location
- Los Gatos CA USA
I have convinced my wife that a lathe can be art, and that art should be displayed in our home.
Her standards are high though, along the lines of this restored lathe.
I could acomplish this with low temperature powder coat, but that might still distort the castings. Does anyone know how this finish was achieved? Hard work and block sanding of course, but what products and any other tricks than hard work were used?
Her standards are high though, along the lines of this restored lathe.
I could acomplish this with low temperature powder coat, but that might still distort the castings. Does anyone know how this finish was achieved? Hard work and block sanding of course, but what products and any other tricks than hard work were used?