shapeaholic
Stainless
- Joined
- Oct 14, 2003
- Location
- Kemptville Ontario, Canada
I am working through the repair of my Aciera F4
As you can see from the picture the front door is bent in.
I have annealed aluminum sheet for forming and straightening using a torch and a water bath to soften the material to avoid cracks.
I have never done this with cast aluminum.
Could anyone give some advise as to how to proceed?
Thanks
Peter
As you can see from the picture the front door is bent in.
I have annealed aluminum sheet for forming and straightening using a torch and a water bath to soften the material to avoid cracks.
I have never done this with cast aluminum.
Could anyone give some advise as to how to proceed?
Thanks
Peter
Last edited: