lazz
Stainless
- Joined
- Feb 12, 2012
- Location
- The warm desert of Phoenix Arizona
Recently a small horizontal mill found its was to my place.... Thanks John...
While cleaning it up Im looking into adding cutting oil or coolant and now would be the time to drill and tape holes. Maybe that dark smelly sulfur oil would add the special scent thats missing to my garage shop.
This is a Rockwell 21-120
The each end of the table is drilled and tapped 1/2 NPT for drains. There is one drilled and tapped 3/4 NTP hole in the base allowing access to the cabinet in the base.
An hour of searching Google didnt show any examples of how folks are connecting the drains at the ends of the table back to the pump...
How do the experts keep the oil on the table or in the tank and off the floor?
Any secrets? Or suggestions?
While cleaning it up Im looking into adding cutting oil or coolant and now would be the time to drill and tape holes. Maybe that dark smelly sulfur oil would add the special scent thats missing to my garage shop.
This is a Rockwell 21-120
The each end of the table is drilled and tapped 1/2 NPT for drains. There is one drilled and tapped 3/4 NTP hole in the base allowing access to the cabinet in the base.
An hour of searching Google didnt show any examples of how folks are connecting the drains at the ends of the table back to the pump...
How do the experts keep the oil on the table or in the tank and off the floor?
Any secrets? Or suggestions?