FullFusion
Plastic
- Joined
- Apr 5, 2012
- Location
- Burlington, Ontario, Canada
I recently picked up a Davis 4 key seater. I made about 45 keyways on the first job and it worked alright but was a bit noisy. Found slop in the connecting rod pin. I figured the bushing were worn and I would take it apart and make new ones. Got it all apart today and it seems like there are not bushings, the shafts just run in the castings.
How would you guys go about repairing this. Bore the casting out and install bronze bushings or bore the castings out and put in oversized shafts to fit the new bore and let it run the same way?
Thanks
Jim
How would you guys go about repairing this. Bore the casting out and install bronze bushings or bore the castings out and put in oversized shafts to fit the new bore and let it run the same way?
Thanks
Jim