I am selling my dad's machine shop, which includes several machines, lots of tools and tooling and raw materials.
First up is his vertical milling machine. I was going to keep this, but I need to get my Bridgeport M head mounted to my horizontal instead.
The mill is similar in size to a Clausing 8xxx mill, but with a slightly shorter table.
Perfect for a home shop, particularly if you need to get it into a basement with no ground-level access.
Information on Arboga mills can be found at:
http://www.lathes.co.uk/arboga/index.html
http://www.lathes.co.uk/arboga/page4.html
Gear head mill, 125 to 3480 RPM. 3-phase
Uses a gearbox to get four different ratios and the motor has two speeds.
250, 830, 1060, 3430 in high,
125, 415, 550. 1740 in low
Includes an Albrect keyless chuck 1/8"-5/8" range on Morse Taper 3 arrbor.
Note that this is not an Arboga-type arbor with the collar, so it would be for drilling only.
Includes a rotary phase converter that Dad used with it.
I checked it out and it started and ran and powered the mill.
The converter is sold as-is.
Included the box with the starter button and all wiring.
The input is 220v.
The mill runs smooth in all gears. The motor is 2-speed.
The high works fine in all 4 selected speeds, but sounds sluggish in the two higher gears.
Fine in the two lower gears.
More pics and text coming - board allows 5 pics per post.
Steve
First up is his vertical milling machine. I was going to keep this, but I need to get my Bridgeport M head mounted to my horizontal instead.
The mill is similar in size to a Clausing 8xxx mill, but with a slightly shorter table.
Perfect for a home shop, particularly if you need to get it into a basement with no ground-level access.
Information on Arboga mills can be found at:
http://www.lathes.co.uk/arboga/index.html
http://www.lathes.co.uk/arboga/page4.html
Gear head mill, 125 to 3480 RPM. 3-phase
Uses a gearbox to get four different ratios and the motor has two speeds.
250, 830, 1060, 3430 in high,
125, 415, 550. 1740 in low
Includes an Albrect keyless chuck 1/8"-5/8" range on Morse Taper 3 arrbor.
Note that this is not an Arboga-type arbor with the collar, so it would be for drilling only.
Includes a rotary phase converter that Dad used with it.
I checked it out and it started and ran and powered the mill.
The converter is sold as-is.
Included the box with the starter button and all wiring.
The input is 220v.
The mill runs smooth in all gears. The motor is 2-speed.
The high works fine in all 4 selected speeds, but sounds sluggish in the two higher gears.
Fine in the two lower gears.
More pics and text coming - board allows 5 pics per post.
Steve