Fadal VMC20 and Matsuura 760v2 for sale -$11,500 for both make offer
Close
Login to Your Account
Likes Likes:  0
Results 1 to 1 of 1
  1. #1
    Join Date
    Jan 2009
    Location
    Melbourne
    Posts
    16
    Post Thanks / Like
    Likes (Given)
    1
    Likes (Received)
    11

    Default Fadal VMC20 and Matsuura 760v2 for sale -$11,500 for both make offer

    For sale in Melbourne Florida. Both run well, are accurate and reliable. I need the room for 2 bigger machines.

    1991 Fadal VMC20, 22"x16"x20" , 4th axis VH65 rotab $6500

    10 hp Fanuc spindle motor and Hitachi drive. 6500 rpm. Unlike the original motor, this doesn't stall..
    New X axis ball screw for a VMC 40, X axis is now 22", replaced 4 years ago
    New X servo, cabling and resolver
    Replaced Y axis resolver
    Reballed Y and Z screws, .0001 backlash, they are not as quiet as a new screw...
    Turcite resurfaced on saddle and table, bronze gibbs re scraped. original turcite replaced in 2005.
    All new lube meters and much of the lube lines replaced
    A axis motor and resolver replaced 18 months ago. A axis drive replaced., new cable and conduit.
    Coolant pump rebuilt
    New low gear shift cylinder and prox switch
    Spindle bearings and drawbar springs replaced 6 years ago, low hrs since
    Software was upgraded in 1996 to the highest revision for that series control

    The machine had synthetic coolant in it, it ate the paint and pitted the Y axis ways. Been like that since 2005, its ugly but functional.

    1982 Matsuura 760v2 $5000


    X 30" Y16" Z 20"

    10 hp 4500 rpm Geared 2 speed spindle-can be set for 6000rpm with a parameter change but will require spindle chiller
    BT40- taper-30 tool ATC
    Yasnac MX-1 control-control and machine manuals included
    Fixture offsets, Macro programming
    Stevens ground sub plate
    2 out of 3 axis drives rebuilt, 3rd replaced
    new memory board
    RS232 and dnc working, comes with cable
    X axis motor new bearings, coolant pump rebuilt
    numerous spare control boards
    Box way construction
    Table guard and chip pan , coolant system has filter to catch small swarf
    Machine cabinets are immaculate inside
    Has some paint missing from synthetic coolant we used to use.
    Spindle and axis are quiet
    Parameters save to file, printed and original tape.
    Vices and tooling not included
    I have a 4th axis control card for it if you have the skills....
    You cannot stop the spindle on this tank.....pure torque

    Attachment 291500Attachment 291501img_0868.jpgimg_0877.jpgimg_0868.jpg

    I have lots of pictures, for more info email me at [email protected]
    These are solid machines that were taken care of. They were run, but not beat and not crashed. They gotta go and we can probably get them rigged out reasonably when my new stuff gets here.


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •