2001 Fryer ET-18, 18x40 tool room lathe with updated /retrofitted Centroid OAK control. Has 10 hp spindle and Yaskawa drives and AC brushless servos. In good condition and well maintained.
Specs are:
18" x 40"
9.125" swing over cross slide.
10" cross slide travel.
37" longitudinal travel.
D1-6 camlock spindle with 2.05" spindle bore.
10 HP Spindle Drive.
Two speed, electronically controlled gearbox. 50-2000 RPM
Also has Dorian 4 position multi-index tool post for 1" to 1-1/4" stick tools.
The lathe weighs around 6000 lbs and I have a forklift onsite to load.
Looking for $8500 OBO. We bought a smaller lathe that better suits the products we make and this lathe is no longer needed and taking up space.
Lathe is located east of downtown Colorado Springs, CO.
Specs are:
18" x 40"
9.125" swing over cross slide.
10" cross slide travel.
37" longitudinal travel.
D1-6 camlock spindle with 2.05" spindle bore.
10 HP Spindle Drive.
Two speed, electronically controlled gearbox. 50-2000 RPM
Also has Dorian 4 position multi-index tool post for 1" to 1-1/4" stick tools.
The lathe weighs around 6000 lbs and I have a forklift onsite to load.
Looking for $8500 OBO. We bought a smaller lathe that better suits the products we make and this lathe is no longer needed and taking up space.
Lathe is located east of downtown Colorado Springs, CO.