Honing station vertical utilizing Superior (now Tennessee Abrasives) components

Over the years we noticed that we needed to size holes accurately for various reasons and so we put together this honing station utilizing Superior Hone components (Manutactured today by Tennessee Abrasives).

The station consists of: floor model drill press wired thru a foot switch (so we could hold on to the parts
with both hands and cycle the drill press on and off) and a reverse switch (so we
could not only expand the size of the hones, but reduce them also) New $900-1200

a complete Model TRK-1000 honing kit with mandrels, stones, and a morse taper
mandrel driver. New cost on this is $1900 today

an additional straight shank mandrel driver if you wanted to install it in a
bridgeport or other machine, new cost $600

50 Mandrels total to about 3 inch diameter estimated new cost about $3500

222 sets of stones + or - some used, many new with a replacement cost of about $3000

30 truing sleeves with a replacement cost of $480

Looking to get $1950 for the lot. I could ship if necessry. Currently located in South Bend, In about 90 miles east of Chicago

email pat at moldshop dot net or call five seven4 292 oh ate 24

You ran these dry ?

No never ran them dry, we used a spray bottle that held an industrial cleaning solution watered down. We found that this did the best job

All hone equipment is sold, however the buyer did not want the drill press, so it is for sale separately.