whamac
Aluminum
- Joined
- Mar 11, 2006
- Location
- Freeport, IL
I'm selling my very nice Hurco VM1.
Bought it new in 2005, and used sparingly in my one-man job shop; never a heavy cut, it's been used for the last ten years mainly for engraving shift knobs for a little hobby/business.
Very low hours for its age. Clean and well-maintained.
Has the MAX control; no graphics.
Comes with a 6" Kurt vise and approximately 30 CAT40 toolholders, all manuals and maintenance records.
Looking for $25K
Or if you're looking to tell the boss to shove it and start your own shop, I have nearly everything you need.
Mitsubishi FA10 wire EDM, Sharp 1118H lathe, Lagun FTV-2L manual mill, all in supreme condition.
Also, lots of small shop equipment.
42 years in the trade, 34 running my own one-man shop, and I'm ready to pack it in.
Let me know if you're looking for anything.
Bought it new in 2005, and used sparingly in my one-man job shop; never a heavy cut, it's been used for the last ten years mainly for engraving shift knobs for a little hobby/business.
Very low hours for its age. Clean and well-maintained.
Has the MAX control; no graphics.
Comes with a 6" Kurt vise and approximately 30 CAT40 toolholders, all manuals and maintenance records.
Looking for $25K
Or if you're looking to tell the boss to shove it and start your own shop, I have nearly everything you need.
Mitsubishi FA10 wire EDM, Sharp 1118H lathe, Lagun FTV-2L manual mill, all in supreme condition.
Also, lots of small shop equipment.
42 years in the trade, 34 running my own one-man shop, and I'm ready to pack it in.
Let me know if you're looking for anything.