whamac
Aluminum
- Joined
- Mar 11, 2006
- Location
- Freeport, IL
Selling my 2012 Lagun FTV-2L manual mill.
It has Servo X-axis power feed, Newall 2-axis DRO, power drawbar, 4" riser block, set of collets, worklight, chipguard, and Kurt D688 vise.
Very low hours on this machine; practically new condition!
Bought new in 2012 for my one-man shop, it wasn't used (or even wired up) for a year.
In 2017, 95% of my work was taken away by my biggest back-stabbing customer of 33 years (Honeywell), so it has sat idle for most of that time.
After 34 years in the job shop business, I am hanging it up and selling everything.
I also have a 2003 Mitsubishi FA10 wire EDM, 2007 Sharp 1118H (Hardinge clone) manual lathe, and 2005 Hurco VM1 machining center; all with very low hours for their ages, all listed for sale on this forum and all under power and available for inspection at any time.
I would like to get $13K for it.
Thanks for looking!
[email protected]
It has Servo X-axis power feed, Newall 2-axis DRO, power drawbar, 4" riser block, set of collets, worklight, chipguard, and Kurt D688 vise.
Very low hours on this machine; practically new condition!
Bought new in 2012 for my one-man shop, it wasn't used (or even wired up) for a year.
In 2017, 95% of my work was taken away by my biggest back-stabbing customer of 33 years (Honeywell), so it has sat idle for most of that time.
After 34 years in the job shop business, I am hanging it up and selling everything.
I also have a 2003 Mitsubishi FA10 wire EDM, 2007 Sharp 1118H (Hardinge clone) manual lathe, and 2005 Hurco VM1 machining center; all with very low hours for their ages, all listed for sale on this forum and all under power and available for inspection at any time.
I would like to get $13K for it.
Thanks for looking!
[email protected]