Milltronics VM17

I have milltronics VM17 I think 1999 model I will be selling shortly. I am selling because it does not have through spindle coolant or chip conveyor. I originally had this as a hobby machine since, It will run on single phase and fit in a garage.

It has
Centurion 6 control (updated to newest software,
Full conversational and g code programming
Dxf import function and graphics
single board computer update with expanded memory
New LCD display
SD/USB drive update
30"x travel, 16 inch y and I think 20"z.
8000 rpm spindle cat40
20 tool changer
Coolant system with filter and wash down
Air blast.
Full enclosure
Grease lubrication system (rebuilt 2 years ago)
New x and y axis ballscrews
New x and y axis motors
All the manuals and parameters
Autodesk post processor for Fusion 360 and HSM
I also have spare parts for backups


The bad
1. The spindle and motor were replaced several years ago and the sheetmetal cover over the right side of the motor was lost.

2. When the y axis ballscrew and motor were replaced the enclosure was cut open and a patch put over the hole.

I may have a few pieces of tooling that can go with it and bunch of retention knobs that won't fit my new machine.

The machine runs good and would be good for a hobbyist starting out.

I am in south Mississippi just outside Biloxi.

Please email me at [email protected]

$10000