Monarch 10EE Lathe, 20" centers
Upgraded to DC Solid State Control when rebuilt, early 90's
6" 3 Jaw chuck
8" 3 Jaw Tru Adjust chuck
8" 4 Jaw Chuck
Face Plate
Drive Plate and centers.
Taper Attachment
2J Collet Set w/ Collet Holder
This 1947 machine is solid and accurate. It was totally rebuilt in the early 1990's, ways ground, all gibs replaced and scraped in and calibrated. The DC drive was upgraded to solid state at this time. It does has some surface rust from being in a moist environment, not on the ways. At the moment there seems to be an issue with the DC controller, I believe someone with a little electronic experience would be able to remedy the situation easily. There is a schematic with the manufacturer info. which may make troubleshooting easier.
$5500.00
Contact: [email protected]
Upgraded to DC Solid State Control when rebuilt, early 90's
6" 3 Jaw chuck
8" 3 Jaw Tru Adjust chuck
8" 4 Jaw Chuck
Face Plate
Drive Plate and centers.
Taper Attachment
2J Collet Set w/ Collet Holder
This 1947 machine is solid and accurate. It was totally rebuilt in the early 1990's, ways ground, all gibs replaced and scraped in and calibrated. The DC drive was upgraded to solid state at this time. It does has some surface rust from being in a moist environment, not on the ways. At the moment there seems to be an issue with the DC controller, I believe someone with a little electronic experience would be able to remedy the situation easily. There is a schematic with the manufacturer info. which may make troubleshooting easier.
$5500.00
Contact: [email protected]
Attachments
Last edited: