Hillside Fab
Cast Iron
- Joined
- Nov 16, 2014
- Location
- Missouri
This was PM member ewlsey's machine that he put quite a bit of work into:
https://www.practicalmachinist.com/...ted/fs-tree-vmc-1260-machining-center-333340/
Machine still looks the same, I haven't done much to it other than replace the Z axis way cover. I think I clocked around 250 cutting hours.
I cant lift it, but I can help you roll it to a 42" hi dock door, or ground level door. The dock door works great for a tandem rollback wrecker to load out.
It's still a pretty decent machine, I want to make some room for a larger one.
$9,500, approx 1hr west of St. Louis.
PM me on here. Thanks!
https://www.practicalmachinist.com/...ted/fs-tree-vmc-1260-machining-center-333340/
Machine still looks the same, I haven't done much to it other than replace the Z axis way cover. I think I clocked around 250 cutting hours.
I cant lift it, but I can help you roll it to a 42" hi dock door, or ground level door. The dock door works great for a tandem rollback wrecker to load out.
It's still a pretty decent machine, I want to make some room for a larger one.
$9,500, approx 1hr west of St. Louis.
PM me on here. Thanks!