steelsponge
Aluminum
- Joined
- Aug 24, 2016
I am looking for arbors to fit my Gallmeyer and Livingston # 15 surface grinder. 3 inch TPF. Also a diamond cutter and fixture to true up my grinding wheels. Thank you, Clyde
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
surface grinder arbors
- Thread starter steelsponge
- Start date
- Replies 2
- Views 1,397
michiganbuck
Diamond
- Joined
- Jun 28, 2012
- Location
- Mt Clemens, Michigan 48035
usually, they are called wheel mounts, wheel adaptors. wheel hub adapters.
Mention the big end. I think you said 1" at the big end?
If so likely that sand a B&S and many other SGs.
Mention the big end. I think you said 1" at the big end?
If so likely that sand a B&S and many other SGs.
Last edited:
michiganbuck
Diamond
- Joined
- Jun 28, 2012
- Location
- Mt Clemens, Michigan 48035
this may be a good deal. but you need to ask about the big end of the hole..and that it is a left hand 1 1/4 tread.
SURFACE GRINDER WHEEL HUB SET WITH WRENCH | eBay
An OK diamond holder
GRINDING WHEEL CLEANER FOR SURFACE GRINDERS | eBay
But just a home made cube of any steel with a 3/8 hole at 15* and a 10-32 ser screw would be fine
perhaps 1 1/2 x 2 x 4" long (?).
SURFACE GRINDER WHEEL HUB SET WITH WRENCH | eBay
An OK diamond holder
GRINDING WHEEL CLEANER FOR SURFACE GRINDERS | eBay
But just a home made cube of any steel with a 3/8 hole at 15* and a 10-32 ser screw would be fine
perhaps 1 1/2 x 2 x 4" long (?).
