What's new
What's new

13 inch Sheldon Lathe

Jim Williams

Stainless
Joined
Oct 3, 2002
Location
Grant, Florida
I have a very worn 13 in. Sheldon Lathe with a 6 ft. bed, probably 36 inches between centers. It is sitting behind the shop covered with a blue tarp. I moved it out some 6 months ago to make room. It has worn 3 & 4 jaw chucks. The change box is off and partially reworked. I think I have a steady rest. Also a few collets and drawbar which I never fitted. It has the cast iron base for the v-belt drive, and an open cast iron leg at the tailstock end. I intended to rework the bed, but the friend with a planer sold it, so I never got that done. Some rust on the bed and carriage. Great for parts or could be made workable with a lot of effort. Free to a good home, or a token amount if you feel guilty. Must come after it, and I will load on your truck with a tractor boom. Located about 30 miles south of Charlotte, in Lancaster County, SC.
Jim Williams

[This message has been edited by Jim Williams (edited 02-16-2004).] Gone. It left on a trailer on 2/21/04 Jim

[This message has been edited by Jim Williams (edited 02-22-2004).]
 








 
Back
Top