Hello!
I run a very small shop doing mostly production cutting for one customer. The equipment I purchased came with a Johnson 35Ton punch press. It powers up and spins but dose not cycle. I have had a couple of people look at it and both think its a relay or two and both requested a manual/wire diagram. Can anyone point me in the right direction? I hope the attachments worked but just in case the Tag says its a model H35 FW-AC and serial number 71051 230 Volt 3phase. Any help would be much appreciated.
Thanks, Al
I run a very small shop doing mostly production cutting for one customer. The equipment I purchased came with a Johnson 35Ton punch press. It powers up and spins but dose not cycle. I have had a couple of people look at it and both think its a relay or two and both requested a manual/wire diagram. Can anyone point me in the right direction? I hope the attachments worked but just in case the Tag says its a model H35 FW-AC and serial number 71051 230 Volt 3phase. Any help would be much appreciated.
Thanks, Al