First off, machine has run fine for months, but last time I ran it was about 10 days ago. Only difference in then and now is 20 degree drop in shop temperature.
Turn on main electrical, all seems fine, turn on control all seems fine...but then it stops right before it normally would turn on servos and red alarm light appears upper left of control face (to left of low oil light) and get "not ready" blinking.
1. No message at alarm messages
2. E stops out
3. Air good (although not needed to boot up anyway really)
4. Everything looks normal in electrical cabinet...LED lights on each module lit, spindle drive LED's lit (power on and speed indicator), no circuit breakers tripped.
5. Parameters and programs seem intact (fresh backup batteries about two months ago as well)
6. Spindle chiller is on and working
Any ideas ?
Milacron
Turn on main electrical, all seems fine, turn on control all seems fine...but then it stops right before it normally would turn on servos and red alarm light appears upper left of control face (to left of low oil light) and get "not ready" blinking.
1. No message at alarm messages
2. E stops out
3. Air good (although not needed to boot up anyway really)
4. Everything looks normal in electrical cabinet...LED lights on each module lit, spindle drive LED's lit (power on and speed indicator), no circuit breakers tripped.
5. Parameters and programs seem intact (fresh backup batteries about two months ago as well)
6. Spindle chiller is on and working
Any ideas ?
Milacron