What's new
What's new

Milling and Grinding

gottabench

Aluminum
Joined
Sep 29, 2007
Location
MN
I have a customer that wants some plates made. We don't offer grinding service so I thought I would put it out here to help him out. There are no holes and or steps. The
plates are approximately .250 x 2.00 x 5.00. On the one side has a radius of .115 and the opposite has a radius .062. Looking down at it from the end it would look like a long skinny cam. The top and bottom need to be ground 16-32 finish.I tried to down upload the PDF but it said it was too large. Not sure why as there is not much on it. The customer would like 25 -50 to start out with and once approved he would probably order around 200 of these.It would be important that these don't get scratched during the shipment.If you are interested and would like a print e-mail me at [email protected]. His contact info is on the print and you would be working directly with him.
 








 
Back
Top