Does anyone know where I can source a 1"-5 2 start acme rod? Or if anyone has a piece on hand?
I need 24". McMaster has 1"-4, and 1"-6, but no 1"-5 in 2 start. I can get tooling to make the shaft but would likely never need them again so don't want to waste money on that.
Thanks
Eric
I need 24". McMaster has 1"-4, and 1"-6, but no 1"-5 in 2 start. I can get tooling to make the shaft but would likely never need them again so don't want to waste money on that.
Thanks
Eric