I normally turn these but my shop is being redone. 3 week lead time. Link is to the print. PM if issues opening/viewing print, or any questions pertaining to the part. Tapping of set screw holes isn’t required; I’ll do that on this end. Thanks.
I’d say there doesn’t need to be any. I’ve never put these units into service so I couldn’t say if that area would impact the function negatively. I’ve made 25 units for a customer that was based on an original, which the print reflects.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.