tonymor
Aluminum
- Joined
- Feb 9, 2017
- Location
- Chambersburg PA USA
Looking for 15pcs of the attached drawing made from 3/8" 6061 aluminium or something similar.
It is a stop for an in house pipe bender, just need a 19.97mm pin to fit through the hole.
I thought a waterjet might do a nice job on them but i am open to whatever.
.dxf/step file available etc.
3" would be fine for the height rather than 75mm if someone wanted to make them from flat bar.
It is a stop for an in house pipe bender, just need a 19.97mm pin to fit through the hole.
I thought a waterjet might do a nice job on them but i am open to whatever.
.dxf/step file available etc.
3" would be fine for the height rather than 75mm if someone wanted to make them from flat bar.