I am looking for about 300 maple plaques with the following specifications:
* Any maple should do - the goal is to match the look of a baseball bat
* Approx 8"x8" (+-1/4") is fine, variation piece-to-piece is OK, as long as it's square
* Thickness - whatever is left over after planing 4/4 boards, I suppose between 1/2" and 3/4"
* S2S and router edged (profile to be decided upon later)
* Hanging slot on the back in the middle (artwork that I will apply is very light and shouldn't move CM)
* 1-2 coats of gloss polyurethane, water- or oil-based, spray is fine as long as it's even
I will want 2 test pcs made and shipped mid to late Aug, but the main order will be placed in mid-September for delivery starting Nov 1, last piece shipped by Dec 1. Quantity and dimensions may change for full order.
I'll answer questions as quickly as I can, and will reply to all responses. I love this forum - it's the place where s%^& gets done. Thank you.
-Mark
* Any maple should do - the goal is to match the look of a baseball bat
* Approx 8"x8" (+-1/4") is fine, variation piece-to-piece is OK, as long as it's square
* Thickness - whatever is left over after planing 4/4 boards, I suppose between 1/2" and 3/4"
* S2S and router edged (profile to be decided upon later)
* Hanging slot on the back in the middle (artwork that I will apply is very light and shouldn't move CM)
* 1-2 coats of gloss polyurethane, water- or oil-based, spray is fine as long as it's even
I will want 2 test pcs made and shipped mid to late Aug, but the main order will be placed in mid-September for delivery starting Nov 1, last piece shipped by Dec 1. Quantity and dimensions may change for full order.
I'll answer questions as quickly as I can, and will reply to all responses. I love this forum - it's the place where s%^& gets done. Thank you.
-Mark