RevMachLLC
Plastic
- Joined
- Apr 10, 2013
- Location
- Michigan, USA
Looking for a shop to machine and deliver an oversized machine fixture plate. Please quote price and timing with delivery to Livonia, MI (Metro Detroit, MI area).
Sketch attached. Material must be a weldable steel, not cast iron. A36 seems appropriate, but I'm open to feedback. End use customer is looking for cost savings, so I'd like to get this quoted two ways:
1) Unground hot rolled finish top and bottom, 1" nominal thickness
2) Blanchard ground both sides to 1" final thickness and black oxided.
Plate contains an on-center grid of 405 qty 3/4-10 tapped holes. Plate edges should be mill supplied finish or equivalent to a slow torch cut. Corners need to have a slight radius (1/4" approximate, snag grinder is good enough, cnc cut is fine too). Edges need to be deburred and free of significant warping and drip if this is torch cut.
Thanks,
Jim
Sketch attached. Material must be a weldable steel, not cast iron. A36 seems appropriate, but I'm open to feedback. End use customer is looking for cost savings, so I'd like to get this quoted two ways:
1) Unground hot rolled finish top and bottom, 1" nominal thickness
2) Blanchard ground both sides to 1" final thickness and black oxided.
Plate contains an on-center grid of 405 qty 3/4-10 tapped holes. Plate edges should be mill supplied finish or equivalent to a slow torch cut. Corners need to have a slight radius (1/4" approximate, snag grinder is good enough, cnc cut is fine too). Edges need to be deburred and free of significant warping and drip if this is torch cut.
Thanks,
Jim