elgoldmann
Plastic
- Joined
- Jun 12, 2020
- Location
- Culver (Bend) Oregon USA
Qty 70 in 1/8 plexiglass, square must be square and onsize to 0.002", big hole in middle can be off the reservation....I figured make big hole first then capture clamp, do perimeter. Leave film on OK, or off OK too. Some scuffing OK, this will be a tray and get marred over time as used.
I'm running out of hours doing other stuff to make parts!
Check in mail day after receipt (of passable parts!), or propose other terms.
Thanks,
Ed Goldmann
Gulch Consulting
Culver, OR
pdf and stp
M3 Stack Bottom.STEP - Google Drive
M3 Stack Bottom.PDF - Google Drive
I'm running out of hours doing other stuff to make parts!
Check in mail day after receipt (of passable parts!), or propose other terms.
Thanks,
Ed Goldmann
Gulch Consulting
Culver, OR
pdf and stp
M3 Stack Bottom.STEP - Google Drive
M3 Stack Bottom.PDF - Google Drive