yugami
Aluminum
- Joined
- Aug 19, 2008
- Location
- Chicago, IL
Guys, Doing 10 of these on my little manual R&D lathe was bad enough. I need about 100 of these for the sample order.
Can't upload the small pdf drawing apparently.
1" long piece of 316 drilled and tapped on one end in 8-32 5/16" deep. Fine diamond type knurl skimmed to take the pointy tops off along the length. Corners broken, tumbling or small chamfer fine for deburr/corner breaking.
Shipped to 46323
PM an email address if you want to review the drawing
Can't upload the small pdf drawing apparently.
1" long piece of 316 drilled and tapped on one end in 8-32 5/16" deep. Fine diamond type knurl skimmed to take the pointy tops off along the length. Corners broken, tumbling or small chamfer fine for deburr/corner breaking.
Shipped to 46323
PM an email address if you want to review the drawing