lbhsbz
Cast Iron
- Joined
- Dec 11, 2009
- Location
- Long Beach CA
The picture below is just like what I need, but none of the available units meet the dimensions I need.
Threads: 3/8-24 x .50-.75
Pin: 0.125 (+0/-.010) x .300" (-0/+.010") from end of threaded section.
Knurl: .6-.8" long, 1/2"-ish diameter. Part can be machined out of 1/2" 6061 stock and knurled on OD...knurled area is not critical, just needs to be knurled.
Quote 500 and 1000 pieces, raw and anodized.
email [email protected]
Thank you.
Threads: 3/8-24 x .50-.75
Pin: 0.125 (+0/-.010) x .300" (-0/+.010") from end of threaded section.
Knurl: .6-.8" long, 1/2"-ish diameter. Part can be machined out of 1/2" 6061 stock and knurled on OD...knurled area is not critical, just needs to be knurled.
Quote 500 and 1000 pieces, raw and anodized.
email [email protected]
Thank you.