SamH
Hot Rolled
- Joined
- Dec 26, 2006
- Location
- Atlanta, GA
I am working on a drawing, but here are some specs/how I make them now.
material is 1/2 304 stainless round
Overall length is 4.5"
Section turned down to 0.375 -.005
Turned down length is 3.0"
Larger end is faced and small chamfer
Smaller end has larger chamfer -no real specs
Here is a pic
Preferable would be to get batches done in what a piece of material yields, and then set as ongoing job as needed.
material is 1/2 304 stainless round
Overall length is 4.5"
Section turned down to 0.375 -.005
Turned down length is 3.0"
Larger end is faced and small chamfer
Smaller end has larger chamfer -no real specs
Here is a pic
Preferable would be to get batches done in what a piece of material yields, and then set as ongoing job as needed.