What's new
What's new

1984 Fanuc btr , Anyone know anything about this ?

The control should be able to accept drip feed from a computer (without using the BTR) if it has a RS232 port.
(usually looks like a 25 pin printer port, but sometimes it's a blue "Honda" connector).

Some of these old Fanuc controls just need a couple parameters changed to enable, or setup the RS232 port.

As far as the ancient BTR unit, you may have better luck with this in the CNC forum rather than Mazak specific.
 
It would help to know what BTR you have, and what Fanuc control you have on your Mazak.
ADR still sells good BTR's that work with the old controls in tape mode, one block at a time.
 








 
Back
Top