What's new
What's new

1999 Mazak QT-250 chuck open / close

gsxr12000

Plastic
Joined
Jun 10, 2011
Location
Wisconsin
Hello, Can someone tell me if the chuck open / close was an option on the 1999 Mazak QT-250 with the fusion control? Also are the M-codes the same as the older machines? M6 to open and M7 to close? If this is an option does anyone know the parameter for this so that I can check it out? Thank you in advance.

Bob
 
Thanks for the replies. I will see if I can find the parameter to turn it on. If anyone happens to know what it is please pass it along. Thanks again.
 
On the T32 machines, the parameter to activate programmable chuck open/close was R49...bit 1 or 2 can't remember.

As said, study your electrical manual's machine parameter list, it will have some translated reference to "auto chuck" or some such wording...

All else fails, call Mazak! Auto chuck open/close has been standard for years, it should have already been set on your machine.

ToolCat
 








 
Back
Top