Hello!
I'm interested to hear if anyone have any knowledge of parameters to adjust the C axis clamp (M210) finish timer in Fusion 640MT (or T, probably the same).
I have found the parameters for the M211 brake, but there is no mention of clamp.
The problem is that using clamp in our Integrex 200SY takes forever. After engaging the clamp (you can hear it engage) the machine just sits there for about ten seconds before moving on with the program. This is a real killer for cycle time.
I tried looking at the PLC manuals but they do not make too much sense to me, I'm not sure how to follow them.
Any help with this issue would be highly appreciated!
I'm interested to hear if anyone have any knowledge of parameters to adjust the C axis clamp (M210) finish timer in Fusion 640MT (or T, probably the same).
I have found the parameters for the M211 brake, but there is no mention of clamp.
The problem is that using clamp in our Integrex 200SY takes forever. After engaging the clamp (you can hear it engage) the machine just sits there for about ten seconds before moving on with the program. This is a real killer for cycle time.
I tried looking at the PLC manuals but they do not make too much sense to me, I'm not sure how to follow them.
Any help with this issue would be highly appreciated!