IronReb
Stainless
- Joined
- May 26, 2011
- Location
- Shreveport/Louisiana USA
1995 Mazak HP20 with T plus control
How does the control set tool change position, based off longest tool sticking out of turret?
Can I control where it does tool change?
Can I set it to approach in Z first then X and retract X first then Z?
I haven't used the TS yet (waiting on parts) but it concerns me the way the tool approaches and retracts, scared as hell I am gonna smack the TS.
Guessing this is taken care of in the setup page with the TS options/barriers?
How does the control set tool change position, based off longest tool sticking out of turret?
Can I control where it does tool change?
Can I set it to approach in Z first then X and retract X first then Z?
I haven't used the TS yet (waiting on parts) but it concerns me the way the tool approaches and retracts, scared as hell I am gonna smack the TS.
Guessing this is taken care of in the setup page with the TS options/barriers?