Diagnos input/output on a T32

benganboll · Nov 4, 2019

I know how to diagnos input/outputs on a T2/T3 but I cant figure out how to find the correct addresses on a T32.
If I look at the attached diagram and I want to see if "Chuck clamp" signal is active I guess I have to look at address XC and bit 7, but how do I display XC? I can only see X0000, X0010, X0020 and X0030.

wippin' boy · Nov 10, 2019

I dont think this is the right page for what you are after
chuck open and close are going to be much lower than "xc"
from there it's been to long since I been in a t32 but it seems you toggle to an "m" or an "mh" something row and type in number you are looking for
but that's all just a swag
someone here has to know. I'm surprised you have not got an answer
maybe it was the ganty "xc" signals that's throwing them

Search

Largest Manufacturing Technology Community on the Web

Search

Diagnos input/output on a T32

benganboll

Hot Rolled

wippin' boy

Diamond

Similar threads