Hi,
We purchased a QT6 with 640T control recently and everything seems to work. We have not done much yet, just messed around with creating some programs. We wanted to run some programs left on the control and the facing bar operations shown by everything CNC on youtube.
Its not clear to us how to change the hydraulic chuck position/diameter operated by the foot pedal. It seems to move from 1.4 close -1.5" open. What if we want to clamp a smaller part say 1"?
I can see the M codes for opening and closing, and not ready for that yet. Perhaps Philabuster will have a video on this?
I only have the electrical manual for this machine and have clicked through a few operational manuals for similar lathes, but haven't seen anything helpful yet
Thanks in advance
We purchased a QT6 with 640T control recently and everything seems to work. We have not done much yet, just messed around with creating some programs. We wanted to run some programs left on the control and the facing bar operations shown by everything CNC on youtube.
Its not clear to us how to change the hydraulic chuck position/diameter operated by the foot pedal. It seems to move from 1.4 close -1.5" open. What if we want to clamp a smaller part say 1"?
I can see the M codes for opening and closing, and not ready for that yet. Perhaps Philabuster will have a video on this?
I only have the electrical manual for this machine and have clicked through a few operational manuals for similar lathes, but haven't seen anything helpful yet
Thanks in advance
Last edited: