xa-mont
Hot Rolled
- Joined
- Apr 4, 2014
- Location
- Victoria, Australia
Hey everyone,
I've always gotten these little blips of rev drop, which isn't a massive deal, but if there's a few blips together on a high load operation it'll drop the revs further and possibly to the point of stalling, which isn't good obviously. And they may be getting worse than they used to be (or maybe i'm imagining it)
The cut it's currently doing sits it at about 50% spindle load most of the time, but that jumps to 60-70 of it bogs down.
Is there possibly a gain setting or something I can assist to fix/minimise these speed drops?
here's a video of the issue (you can hear it physically bogging down)
Shared album - Travis Hammond - Google Photos
Cheers,
Trav
I've always gotten these little blips of rev drop, which isn't a massive deal, but if there's a few blips together on a high load operation it'll drop the revs further and possibly to the point of stalling, which isn't good obviously. And they may be getting worse than they used to be (or maybe i'm imagining it)
The cut it's currently doing sits it at about 50% spindle load most of the time, but that jumps to 60-70 of it bogs down.
Is there possibly a gain setting or something I can assist to fix/minimise these speed drops?
here's a video of the issue (you can hear it physically bogging down)
Shared album - Travis Hammond - Google Photos
Cheers,
Trav