What's new
What's new

Makaz Slant Turn N40 Mazatrol T2

Leonhaldron

Plastic
Joined
Mar 12, 2019
Mazak Slant Turn N40 Mazatrol T2

Hi,

New to the forum and in need of some help!

The company i work for inherited a machine, as above 3 years ago and since has only worked for a short period of time by a chap who has now left. Weve now got the operator from the previous company in to try and show us how to work it but some settings (i think its parameters) have been changed and hes never had to mess with them previously.

Hes remembered how he used to set the tools, We've done the program but when we've come to run the program with no material in just to try it the tool goes to the extreme parameters, away from the job. the jaws have been clamped up so were sure that's not the problem but were now stuck.

Any help or advice would be appreciated.

Thanks,
Leon
 
Last edited:
Assuming you have set the z work offset. Check the user parameter P2.
This controls tool change position.It can be set 0 through 4.

X Z
0=clearance position clearance position
1=machine zero point clearance position
2=clearance position machine zero point
3=machine zero machine zero
4=fixed point fixed point
The clearance positions are dependent on tool length offsets.

Hope this helps
 
Good day... new to posting... need help with parameters for our Mazak... have all the parameters.... but could use some help at a stand still for several days.. please email me [email protected] so I can communicate plz
 
Have you entered all paramaters?
Does it go away in both X and Z?
Have you set Z-Offset under "Program file"?

Give me a ticket from Sweden and I come help you ;)
 








 
Back
Top