Working to re calibrate the tool setter on a VCU 500A 5X after a crash left the B-Axis home position off thus effecting the tool setter. Probe pad has been adjusted flat once again, now i just need to find the probing macro to reset the Z height of the tool probe. Also looking for the parameter in the control that stores said Z height. If anyone else has information on how i could also change my B-Axis home position it would be greatly appreciated.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Matrix 2 tool probe parameters
- Thread starter fryej97
- Start date
- Replies 0
- Views 1,328
