Hello all I recently picked up 3 mazak cnc mills from auction. For the life of me I cannot get a program on or off of the floppy drive. Every time I try I get a Alarm 557 (designated directory not found.) I do not have RS-232 at this time so the floppy is my go to for the moment. The program is a Mastercam program with a EIA extension. I am not sure if the drive has been turned off by a parameter or just a wrong procedure. Being around HAAS for the last 15 plus years has boxed me in a little with the operations of different controls. Any help or procedures would he me greatly
Travis Kirlin
Vroom Engineering
Travis Kirlin
Vroom Engineering